Tiza Group

Home / Guides / Testing, commissioning and faults / Power transformers

Power transformers

Testing, commissioning and faults

Zero-Sequence Impedance (Z0) in TransformersWhat the zero-sequence impedance (Z0) of a transformer is, why it matters for ground fault studies and protection, what sets it and how to interpret it.Frequency Response Analysis (FRA): What It DetectsWhat FRA or SFRA is on power transformers, which winding deformations it detects, what IEC 60076-18 and IEEE C57.149 require and how to interpret it.Transformer Excitation Current Test: What It RevealsWhat the excitation current test of a power transformer is, what the per-phase and per-tap current pattern reveals, and how the results are interpreted.Short-Circuit Impedance (%Z): What the Test RevealsShort-circuit impedance (%Z): why a change reveals deformed windings, what the standards require, how to interpret it and how it is tested in practice.MT, AT, EATPower transformer commissioning testsPower transformer commissioning tests: what is measured, in what order and how results compare with factory tests, and what maintenance requires next.MT/AT/EATShort-Circuit Peak Factor and X/R RatioHow IEC 60076-5 calculates the first peak of transformer short-circuit current: the k√2 factor, the X/R ratio and the default values used when X/R is high.MT/AT/EATThermal Short-Circuit Withstand: 2 s and TemperatureThermal short-circuit withstand in IEC 60076-5: symmetrical current, 2 s duration and the maximum winding temperature after the fault, and its limits.MT, AT, EATOil in Service: Good, Fair and Poor ClassificationHow IEC 60422 classifies transformer oil in service, what to do with each result and why a single value is not enough to decide on its own in practice.MT/AT/EATTransformer Loss Measurement and UncertaintyWhy the phase angle error dominates load-loss measurement of a transformer and what IEC 60076-8 requires for traceability and measurement uncertainty.MT/AT/EATShort-Circuit Withstand: Categories and Design CurrentCategories IEC 60076-5 defines for transformers, the minimum impedance it recognizes and how the short-circuit current is calculated. We can run the study.

Other topics in this section

WhatsApp