Home / Guides / Testing, commissioning and faults / Power cables
Power cables
Testing, commissioning and faults
MT, AT, EATPower Cable Diagnostic Tests: VLF, Tan Delta, PDWhat each power cable test detects: insulation resistance, VLF, tan delta, partial discharge, sheath test and TDR, according to IEEE 400 and voltage level.BT, MT, ATUnderground Cable Fault Location: MethodsHow a fault in a buried power cable is located: analysis, prelocation with TDR or surge methods, route tracing and pinpointing, per IEEE 1234 guidance.MT, ATHigh-Resistance Cable Faults: ARM, ICE and DecayWhy TDR cannot see high-resistance or intermittent cable faults and how to pre-locate them with arc reflection (ARM, SIM/MIM), impulse current and decay.MT, AT, EATCable Partial Discharge Testing: IEEE 400.3How partial discharges are measured and located in installed cables: VLF, DAC and resonant sources, reflection-based location and IEEE 400.3-2022 in use.MTSplice or Replace an MV Cable After a Fault?How to decide whether a faulted medium-voltage cable is repaired with a splice or replaced: cause, insulation condition, splices, age and cable type.MT, ATVLF Testing of Cables: Withstand Voltage and IEEE 400.2VLF testing of medium-voltage cables: why 0.1 Hz and not DC on XLPE, what IEEE 400.2-2024 sets and what IEC 60502-2 asks after installation, in practice.MT, AT, EATCable Sheath Test: DC Voltage and Leakage CurrentCable sheath test for MV and HV cables: when to do it, how to connect it, what the leakage current shows and what IEC 60229 and the cable standard require.MTVLF Tan Delta Cable Testing: Reading and CriteriaWhat VLF tan delta measures on medium-voltage cables, why it is done in voltage steps, the three IEEE 400.2 readings, how to read them and their causes.BT, MT, ATTDR Cable Testing: How to Read the TraceHow TDR works on power cables: pulse, reflection, v/2 velocity, splices and faults on the trace, why it misses high-resistance faults and how to read it.MT, AT, EATCable Sheath Faults: Step Voltage LocationHow to pinpoint a sheath fault on a buried cable: pre-location with a bridge and exact point with step voltage, probes and pulsed DC.